A secure connection when the hand is not a clamp. antiquated method
It is necessary to connect the hose to the pipe or fitting and clamp on hand there. Make a wire brace and clamp it with pliers. To achieve sealing it is almost impossible. Slightly nedokrutili - got loose fit and flow at the site of stranding. Just a couple of revolutions - a wire breaks off or cut the hose. There grandfather device that allows you to forget about the problem with collars.
Make a device for applying a bandage
Take appropriate sized metal plate. From one end of the middle propyl we do a couple of millimeters. Then grinder metal cut away on the sides so that they form a wedge. See sketch.
The dimensions of the plate may differ from the drawing. They can be guided, but not necessarily strictly observe.
To take a smooth knob of hardened steel rod. If the metal is "raw", quickly deform the hole. The configuration of the driver can be arbitrary. We stand a few points:
- The diameter of the holes in the capstan determines the maximum thickness of the wire used for the shroud.
- The thickness of the bar are chosen so that the wall remains at least 3 mm after drilling.
- The diameter of the holes in the plate should match the diameter of the driver.
The principle of operation is simple. Jumped on the hose wire double loop, as shown in the diagram. Threaded holes in the knob. We stretch. Cut the excess - is ready.
IMPORTANT make it a double loop (see. a photo)! Only this way of posing the band guarantees tightness. When a single harness may appear to flow at the site of stranding.
Thank you for reading! If the material was useful, subscribe to the channel. I think you will also have an interesting article about the production reliable scaffolding from scrap materials. Special thanks for sharing articles with your friends on social networks.