Laying on top. What I encountered?

Masonry walls - it's like climbing a mountain peak. The higher, the more difficult... But the closer the target.

Fifth row, I was putting on a piece of rising unit, laid the foundation. Of course you can continue to fence something gradually increasing height, but I decided to just make the basis of which it will be possible to complete before the end of the clutch.

For this I used 50h150 25h100 and boards that I had, and the pallets out of aerated concrete.

Many times I saw the forests were built around the perimeter of the room. Of course it is convenient, but this extra cost to me.

So I proceeded from the fact that I had. So I made one section in each room, but that could be moved along the walls.

◼ On the one hand it is uncomfortable and very slow process. But actually the work is only increased to drag these forests.

🔹 But new challenges are added to everything.

Zataskivanie blocks.

It spent most forces. When laying the first rows is sufficient to take the unit and put on a solution, then starting from the fifth row has to do everything in stages.

1️⃣ Throw blocks on forests

Then climb to 2️⃣

3️⃣ And only then put on a solution.

A lot of movement up and down

For me it is not so much the increase in labor costs as increased time to the clutch. Compared to the first rows of all moves much slower.

Alertness at work.

This factor also adds retardation in(at least for me). When the ground a half, two meters, it is already beginning to think about all the movements. And with increasing altitude, I think everything will be even more difficult.

But not so scary.

Of course with the advancement in the construction of new difficulties arise. But every time I am convinced that with all you can handle.

Let the first with caution, but most importantly with confidence and without fear of error. A further practice will correct all.

And one after another series of gradually increasing ...

💥 subscribe to CANAL 💥and do not miss all the fun.