How to install blades in elektrorubanok.

It would seem a simple question: "How do I install the blades in elektrorubanok?", but after installation, especially when for the first time and situation "did not know, and even forgotten" plane starts planing in a strange way, the Whittle one side, one knife, something else something.

In this publication, I will talk about their experiences during the installation of knives. Perhaps you will not find anything new, and maybe this stuff will be quite useful.

I have an inexpensive elektrorubanok, knives it uses disposable double-sided.

To replace the blades in the first place they need to be pulled out. Planer overturn sole to take the key top (usually is complete with a plane) and begin to tighten the screws in the knife block.

Here it is necessary to tighten, that is, to turn in a clockwise direction, because these blocks are placed at the disposal in the groove of the planer drum.

After loosening the fastening block extract with a knife and purify it from adhering resin and shavings.

After cleaning, turn over the knife blade if the other party has not been used, or set a new one. Gathering unit with a knife and put in the groove of the drum. Unscrewing the central bolt slightly fix the knife.

Check that the knife does not come out to the side of the width of the planer sole.

In such a blade unit has a couple of screws hexagon, which allows you to set the sole of the parallelism of the knife planer.

To adjust desirable to use a straight line or square, and for convenience and to better see how the blade height can make the backlight side of the planer.

The front sole of the planer do not necessarily produce "zero" even better than her little left out because the line will rely only on a fixed sole planer.

Next, using the Allen key expose the blade height so that it lightly touches the line. For the best settings can be a little shake the drum back and forth to catch the top spot.

This setup is done first blade height from one side, then the other. As I said before lighting the side helps to better see the moment of the contact line of the blade.

After that unscrew the extreme bolts to tighten nozhh. It sometimes happens that the final tightening of the blade setting a bit astray. Therefore it is better to double-check the level of the knife on the left and right edges.

If the setting has got off, then we weaken the hardware and repeat setting.

Sometimes a clear explanation with the help of video and so I propose to see and hear about the installation of the blades on the video.

If you liked the article, put the Huskies.

Alexander.