Universal means for sealing the slits

In many cases, you may encounter a problem when an urgent need to close up the gap in the wall, the floor or the like between the wall and the bathroom. The shops sell various kinds of special equipment that is easy to help cope with the problem. But what happens when the hand does not have a silicone sealant or foam?

There is an exit. You can personally make a universal means for sealing cracks and even in some cases the holes. consider the method of preparation of the substance. For this we need only two main ingredients and the vessel in a deep metal plates.

We take our plate and pour it acetone. The amount of acetone is directly dependent on the desired amount of substance. e.g. if you need to seal the small gap in the floor 5 cm, it will be sufficient with 100 ml of solvent. In general, you can adjust to any specific case.

Now we need another building material. In his role will be the most that is not on is the usual foam. It will need quite a lot. It must be by a few throw in acetone. that he's dissolved. Ideally, we should get a very thick consistency. as in the photo below.

Previously, such a tool generally used for bonding wood or plastic. The effect is pretty decent, but now on the other. When we have achieved the desired consistency is necessary to wait. that it has cooled down a bit, since the foam contact with acetone, a chemical reaction with heat.

Now it remains for small. Fill the gap and the substance with a spatula uniformly smeared over the surface. We are waiting until the dough hardens. Usually it takes two to three hours time.

One of my neighbors to testify at all came up with this tool other use. Its roof was full of holes like a colander, and money in his coat was not. So, this means he smeared all holes and already two years does not know the problems with the flow.