Device for cutting foam hands.

Greetings to all subscribers and just channel my readers. Today will tell you how to make a device for cutting foam hands. Thanks to this device you can cut from foam absolutely any shape, any size in seconds.

For manufacturing, we need the basic things that are home almost every, if not, they are not difficult to buy.

And so, to begin with we take two of the same along the length of a pencil.

They need to saw off the pointed ends. This can be done by holding a pencil in a vise and use a small hacksaw on wood.

Now it is necessary to drill through holes at opposite ends and by means of pencils screwdriver to screw one screw with nuts. Photo below.

Next, we will need the battery compartment. On its sides glue sticks with hot melt glue. You also need to stick to it a simple switch.

Using wires connect compartment switch. then summing wires twisted screws on the pencil and use a screwdriver to fasten.

It remains the case for small. take Nichrome thread and connect it with the screws with nuts.

The result was an excellent device, which can be useful in an economy when working with foam

If you like this idea, then be sure to subscribe to my RSS feed and place the thumbs up. There is a lot of useful material. Thanks for attention