Finishing putty slope "cartoon" without sanding

In anticipation of the completion of a series of posts about window installation and finishing slopes a bit of finishing, then the only painting left. Putty slope so that later it was not necessary to resort to his sanding! Many doubt that this is possible, but to achieve the goal that does not stop. He worked as a filler like "multi-finish "Although the usual finish is not that worse.

Several months ago, already had an article "Caulking without grinding ...", so check out who is interested.

Before filler, in those places where a layer of putty home the fattest, the slope was still damp (Photo 1).

In advance, it became clear that the layer finishki there will be less, since the dry part of the moisture once absorbed, and this in the course of alignment allows adding another layer on top, whereas the wet coating station in greater numbers for crawling spatula.

Important conditions for a good result

1. For high-quality processing of the slope finish spatulas and containers must be clean.
instagram viewer
2. putty is mixed to the density of higher than average. With a spatula falls.
3. Slope pre-clean spatula from large irregularities initiator layer and removes any perceived fingers large grains of sand.
4. Well cleaned and spatula neaten brush corners and places of contiguity to the window frame.
5. Escarpment primed before applying the finish do not do it, it slows down the absorption of moisture during operation.

He started with a putty puttying putty corners and joints with a window sill. I am doing it with your finger, as better tool has been invented! Then normal operation over the entire surface from top to bottom in small portions.

After the first campaign immediately goes even more. During this time moisture from the filler tightened wall and the layer can be derived without sagging.

In the course of his fingers a few times had to remove grit from the slope. Even in places where the layers were necessary to reduce the transitions are not visible. All the plane eventually turned rovnenko and do not require subsequent sanding. Very small nodules poostavalis only on the outer corners, and then, because he had forgotten to remove them immediately. For details, see the video.

Evaluate material andsign upCanal.

ANDit is interesting:

Rough putty slope. What to consider

Mole-shovel. strong impression

How to align the slope perforated corners