Useful content

How to clean the surface of the walls

click fraud protection

The hardest part of any repairs - quality training walls to finish. On the purity of cleaning the surface of the old material it depends on the quality and durability of the repair. Therefore, the walls cleaned very carefully and accurately.

Remove the old paper wallpaper easier. It is not necessary to tear them into small pieces. Better to take a liter of warm water and pour into a container with a sprayer. Then apply the water to the wall from top to bottom 1 again, and then once more and wait 5 min. Wet wallpaper can also be a sponge or roller. After that paper wall will easily move away from the wall paintings, and all the work will take a few minutes.

With vinyl wallpaper it is more complicated. The dense outer layer - is waterproof. So we have to hook blade spatula from above or below and slowly detach from the wall. On the wall may remain lower paper layer that is easy to use as the basis for new wallpaper or remove the aqueous solution from the wall. If vinyl wallpaper tightly glued and do not depart, it is necessary first to cut them with a knife across the building on the surface. This should be done at a distance of 1-2 cm. Then, on the surface of the water spray 2-3 layers and wait for a few minutes. After that, the wallpaper is easy to move away from the walls. With the same objective to strip easy to handle.

instagram viewer


Tile from the wall will have to tear off with a hammer and chisel. You can use a hammer or chisel. The main thing is not only to remove the tiles, but also the old tile adhesive to the base, otherwise the wall will not even.

If the walls were painted, they should be skinned. It should be reserved by sandpaper or a mesh construction with large and fine grains, and a special tool for fastening the sandpaper. First wall sandpaper tested with large grains for removing the top layer of paint. And then sanded smaller numbers nazhdachki. The entire top layer of paint must be carefully removed, otherwise the new material on the surface will not be held. For sufficiently smooth surface shkurit wall to perfect flatness is not necessary, on the contrary should be left a small crack for hanging the adhesion of a new surfacing material with the walls.
After thoroughly cleaning the walls need to be primed and dry, and old wallpaper or tile to throw and carefully sweep the floor. Only then can we begin for further decoration.

Power bank with solar panel how much more efficient than usual

Power bank with solar panel how much more efficient than usual

Hello dear guests and subscribers of my channel! Today I want to talk with you about such an elec...

Read More

I tell you what I put in the Hole when I plant Cucumbers in the ground. The harvest pleases from year to year

The development of a plant depends on what it will eat in the first days after germination. With...

Read More

Humic fertilizers for garden and vegetable garden: description, properties, methods of application

Humic fertilizers for garden and vegetable garden: description, properties, methods of application

Gardeners and gardeners tend to use environmentally friendly organic fertilizers, which include m...

Read More

Instagram story viewer