Stuck and puffed punch. Repairs

Sorry, but my old 10-year-old super-reliable punch still caught wedge. Immediately became not repaired, as there was urgent work, and I bought new- long I planned. But now it's time to tinker with the old man, and if possible bring him to his senses. And it happened, though!

As it turned out, the matter bearing anchorWhich was scattered and had to be changed for the second time. Past replacement was 8 years ago. Then the lower part of the cylinder, or rather its cover, because the bearing is heated so that several times burned hands.

The hardest thing was to get and remove a melted bearingWhich is pressed onto the armature shaft. For this it was necessary to unscrew a vertical cylinder with a handle. The upper unit does not touch, just put aside.

Holding the cylinder to get the anchor, first had to be on it from the bottom, unscrew the two screws coverInto the slot in which the bearing is pressed too lightly.

A few minutes later, hooking cap blend, then one, then on the other hand, it was possible to remove, and then anchored to the bearing pulled over the top. Cover like duralumin, so chisel worked very carefully. Brush on the sides of the cylinder is not pulled, as the plastic nut on one of them firmly baked onto the past overheating.

Puller at the first repair I did not, because of which the bearing anchor grinder and cut the shaft left a mark. At this time, the anchor took with him to the market and when to buy a new bearing, asked an acquaintance seller remove the old bearing puller. He gave a stripper and in 3 minutes it was done.

Already home to the rubberized handle of a hammer planted a new bearing on the armature shaft, then I put the anchor in place, only the first through the lower hole on the cylinder had to push the chisel blade. And there were still a new bearing to fill the very cover. It also made a handle of a hammer, holding a keg-cylinder in his hands.

The hardest part behind, just need to put it all together and check. And in the course of the upper portion unscrewed with a special key and the plastic cover to grease natolkal - lithologic. And added a little grease from the bottom opening, where there is another bearing.

Lubrication though not special, but for the past two years it has proved to be a good idea.

The assembled apparatus was started as a new one. Comments yet. The bearing is not heated and perforated beats as before, so that seems to serve more. And to all you propose to briefly share my thoughts on the expense of the done.

Evaluate material andsign upCanal.

ANDit is interesting:

"And so it will come down." How to insulate a house on the curved foundation

How to buy a new low-cost punch

Soldering pipes homemade soldering iron. Powered by gas and fire

Aunt froze: Box of another radiator and "Tashkent"