Installation of plywood to the frame in the finishing of the walls

Owner is available to the modern variety of materials that can be used to align the walls to further inflict on them the paint, wallpaper or other finishing materials. But today plywood that someone considers outdated, it is still actively used. After all samples are available now, we are endowed with very good practical characteristics. But how to install the plywood walls in alignment?

1. How to prepare a wall to work

Thorough training is not required, but without deleting the previous material is better not to do. After all, underneath mold sometimes found lesions or cracks. Mold should be cleaned mechanically, then apply an antiseptic. Cracks removed using plaster composition.

2. How to set a framework for plywood

Directly on a rough surface to lay the plywood is not necessary, because then the sheath may have weak smooth and reliable. Correct prepare carcass structure using beams of 5-10 cm thick. Placed vertically, keeping a gap of about 70 cm. Although when using veneer thickness greater than 18 mm, the pitch can be increased.

Also, for greater structural rigidity of the timber racks can be connected bridges in some places. In principle, it is sufficient only two jumpers on each flight. Only here there is an important requirement in the neighboring bays jumper necessarily have a different level, but not in a row.

3. How to attach the plywood to the frame

This event is characterized by extreme simplicity. Plywood is placed in the frame and attach it with screws. And it is necessary that the edges of plywood lying on a bar, not hanging in the void. Otherwise paneling will be deformed. Plywood sheets arranged at intervals, which must be not more than 3 mm.

4. As zashpatlevat seams in the casing

If the owner is planning to lay plywood adhesive tiles or wall panels, we can do without shpatlevanija seams. In the application of paint or wallpaper as a finishing material sealing gap filler is a mandatory task. Building structure placed between the sheets, and then carefully smoothed and triturated on the surface. It is necessary to achieve such an effect that the filler did not stand out against the background of the plywood sheathing.

Preparing such a structure, it will only be primed prior to laying decorative materials. In such a plywood sheathing can be laid virtually any decorative finish.