Putting trimming PVC tubes for 2 min. Tools are not required

Sewage pipes of PVC with cut sockets and without additional couplings bought basically useless, but whether or not to throw them out? In fact, when using non-standard ways to connect, they can be on an equal footing with the whole and without sleeves. One need only spend a few minutes in the molding of a new flare.

Important! Based on the direction of flow, followed immediately determine which of the circumcision pipe will funnel. As a rule, it is located on the near side in the direction of flow.

Step 1

One tube is made beveled - beveled edge. Possible without chamfer try, but it's a bit more complicated technically and requires more muscular effort. To drive the chamfer can use any abrasive. Also worth a little trim the edge of the other pipe, so as not to interfere with burrs.

step 2

Attention: building hairdryer (he shows), Boiling water, gas flame cookers, portable burner, a fire or an electric warm up over the edge of the pipe on which the socket will be formed. Warm-up takes about 1-1.5 minutes. Pipe at the same time should slowly rotate for even heating. Overheating is not necessary, it is better not dogret little, and then, if necessary, once more to walk.

If working on the fire, not to the melted end of the pipe, the flame side, covering up to 5 cm tubes.

Even if the house is not building a hair dryer, just reheat tube over gas stove or boiling water - this is a separate article! You definitely will!

step 3

After a one-minute warm-up begins forming the socket. Chamfer other pipe after several movements inside edge of reheat it expands and enters into the tube without any problems. For reliable connection 5 centimeters is enough. If the connection still have to parse, the pipe need to scroll within a couple of minutes until the bell has cooled down and begin to take shape.

Even without such a sealant compound is quite tight and unlikely to flow. If inserted into the pipe does not twist, the heated end of it is even better obozhmet and maximum sealing connection.

step 4

Sealing. It is performed for insurance. This can take some of any polymeric adhesive, quick-drying glue, silicone, liquid resistant nails and others.

ATTENTION! And here's a link for a change in the very informative Zen channel my brother - railwayman

The compound obtained is very dense and durable and not inferior in reliability factory.

This connection method does not prevent the normal flow of water and does not contribute to the formation of fatty plugs so that, if desired, in this way you can easily get out of the difficult situation in the building in the country or suggest yield neighbor.

Evaluate material andsign upCanal.

ANDit is interesting:

Rapid method of removing rust. Activated for 5-7 minutes

"To be or not to be" whether the ceiling primer needed before painting

Forgotten trend of the USSR: the chain of wire with his hands