As plastered the room with his hands

room stucco begins with dismantling operations, in a simple way to recapture the old plaster from the walls. It's very dusty and unpleasant in terms of injury to the process, but it requires us to further plastering. Once we have mastered the dismantling, swallowed dust (by the way is better to wear a respirator), scratched and cured broken-off fingers with a hammer (a hammer to beat the plaster is better), but still decided to do instead of specialist plastering then proceed.

To start to define the tool that we need to work it: level, trowel, bucket solution (preferably a wide pelvis), Nylon thread, polotor, float trowel. If you do a simple plaster (without leveling plane), it is enough to trowel and polutera, but we are going to do high quality and beautiful - on beacons.

Buy at the hardware store plaster beacons dowel screws and begin to set the beacons. To start hammer drill holes (diameter dowel) in the lower left corner of the room, followed by the middle of the room at the bottom and the bottom right corner. Then do the same procedure in the middle of the room, and finally in the right-left corners and the middle of the top of the wall. Hammered to dowels and screw the screws so that the screw cap peeking out of dowel 1 cm. Then puts long (2 m.) The level of the lower screw, and is exactly in coincidence (air bubble between risks) and unscrew or twirl (if necessary) the remaining two (middle and upper) screws to the touch level plane. And so with the other two strips of screws (on one wall 3 usually comes lighthouse). Between the corner beacons (the top, middle and bottom) 3 stretch the nylon yarn and secondary screws expose on a thread.

Next, a thin wire beacons to fasten screws. All our beacons installed perfectly in level, you can proceed directly to the plaster. Knead the solution with a trowel and immediately jump on the wall, but for this operation, you need experience and skill, for the layman is better to use a spatula (20 cm.) Or plaster ladle. Spreads from bottom to top, between the lighthouses of about 50 cm strip, do it quickly is not the solution could dry up and as quickly placing your rule to the beacons are conducting them from the bottom up, remove excess solution. Wall in front of solution spraying necessarily moisten with water, after we threw and removed the excess solution take polotor impose on it a solution thinner and zigzag movements hammering all voids and hollows shell.

Finally take grater and circular motions begin to overwrite the plaster, thus dampening the wall, the best of bryzgalki not much water wall. After drying, the wall is usually 72 hours gruntuem wall deep penetrating primer and then you can think of what to trim the walls on. Good luck to repair.