Useful content

How to insulate a loggia Penoplex

click fraud protection

Some owners try so equip the loggia of the apartment, so that it became an independent dwelling. There can not do without high-grade insulation. Run it is possible, using modern penoplex. This heat insulator, which can be placed on walls balconies and ceiling as needed.

1. preliminaries

To put penoplex qualitatively work surface to start to explore. It will have to remove the previous cladding coatings. Maybe somewhere there are cracks that can not leave, as they significantly reduce the protection from the cold. Point of cracks and crevices even obscure for ordinary concrete solution.

2. Setting the frame structure

Of course, you can penoplex and immediately stick to the rough surface, but then later have difficulty in carrying out the finishing activities. For this reason, correct to start to collect the carcass structure. It is performed using blocks of wood with a thickness similar to the thickness of the insulation boards.

To use the balconies usually sufficient Penoplex panel 5 cm thick. Accordingly, the bars should be the same. Of these, form the harness on the perimeter of the window unit. Then, attach the vertical posts on the outer wall of the loggia, the side walls and on the ceiling. Between them should be a distance of about 50 cm.

instagram viewer

3. Bookmark insulation material

Penoplex - product successfully retains its geometry and dimensions even in the presence of mechanical loads. Therefore easy to handle with it. Fundamental point: the owner must cut foam plates at once so that they are included between the framing members tightly, leaving no gaps.

Because of this panel should be slightly wider than the distance at which the bars are installed. For example, the sheets can be cut into a width of approximately 52 cm. If penoplex once securely held, stick or grab it on the dowels is not required.

4. Finishing events on the loggia

Forming a heat insulating layer, proceed to finishing activities. Options for their conduct in this case is set. For example, you can simply install the carcass structure wooden battens. Fit and trim panels, which are also directly attached to the frame. In some cases, suitable moisture-resistant gypsum board, which sheathe the carcass structure and then apply paint or wallpaper. In general, the options abound.

Country life today: how to protect your home from coronavirus

Country life today: how to protect your home from coronavirus

Official data, opinions of FORUMHOUSE participants, rules of outdoor recreationIn the context of ...

Read More

Why boric acid for the strawberries?

Why boric acid for the strawberries?

The process of fruiting strawberries affected by many factors: soil, watering, weather, lighting,...

Read More

Top 7 of tasty pickles, which are good in salads, not only

Top 7 of tasty pickles, which are good in salads, not only

None of you will not give up a fragrant, fresh and crunchy cucumbers without bitterness. A growin...

Read More

Instagram story viewer