A new way to accurately trim ceiling moldings. Master OK

I welcome you to the channel of simple and effective ideas!

Agree to work a special tool is convenient, but many if he is? That is why the share as having no experience, you can trim the ceiling moldings on the inner and outer corner. Miter and angled scissors do not need. Believe me, this method will be mastered by even the most lazy. Getting Started!

To work need: 1. Building a knife. 2. Triangle with an angle of 45 degrees. 3. Pencil.

Equipment cutting the inner corner

Model the workflow improvised plywood ceiling and corners. First prune baseboard by the corner.

1. From the top corner on the ceiling I draw a line at 45 degrees length of 5-7 cm. If the angle is not 90 degrees, more or less, just divide it in half line (Photo 2a). To draw a line using an isosceles triangle, but it is possible to handle and line, even though it is in a corner of its shape does not go down.

2. I receive plinth on either side, looking for some end face of the corner and is firmly pressed. With a sharp knife from the top corner of the cut-through doing, focusing on the line. If desired, you can draw a line on the baseboard and cut hands.

instagram viewer

It is important to hold a knife properly, not pulling it in hand, only under this condition the junction turn right.

3. Similarly, the other strip do trim (photo 3a) And to verify the result of combining the two in the corner moldings. Even if there is a small gap, with a knife it can be easily remedied by further trimming, re-placing your plinth in the corner, or do without it.

Trimming the plinth at the outer corner

In general, the method is similar, but it is still worth a look at it.

1. Again divide half angle line (Photo 4a). Here and line approach. If the line on the ceiling and then have to wipe, do it fine, and then indulge in an eraser. If the outer corner straight line is obtained under 135 degrees.

2. I cut right plinth (Photo 4b), After a little pulling the edge of the line and do the same with the left side (Photo 5a). Again, watch the right position of the blade.

3. I combine finished strip on the corner, and appreciate the aesthetic situation (Picture 5b). Blot, of course, there are even in the middle of the visible light dent due to blunt blades are generally a good result.

I am sure that after a few scores in you all will come out as "excellent"! Evaluate article Like and comment.Subscribeper channel, so as not to miss out on something new and useful!

Read more: