Is it possible to glue the tiles on a wooden floor? Master OK
Greetings to all inquiring minds on the channel and I can say that we are talking about laying tiles on the floor, which he did a few years ago to remove the most intrigue. Original photo with the wooden floors can not offer, because, due to limitations of the project, did not think about it then. But the fact that the tree tiles perfectly kept for 5 years - a fact reinforced concrete and indisputable. If in the near future get on the subject, be sure to click a couple of times, and will set the reference pictures.
If you have something to say on the subject, please write in the comments. the experience will be even more interesting and useful to expand.
Terms of performance styling
- Even if there were pictures with the referenced object, you still would not have noticed them on the bare boards covered with tiles, as directly on the wood tiling is not performed. The wood for this is simply not adapted. Sex covered by special plates required high rigidity and relatively high strength. About them below.
- To improve the functionality of the floor with wooden base Doschatoe I recommend advance to eliminate all possible shifts general floor, individual boards and the creak. Bad helps further screwing boards to lag screws. Sometimes I had to scroll through each board to lag, but then the floor stands a monolith and no beeps.
- Sometimes, before laying tiles to bring the gender order had to pluck a couple of boards and work with lags, since they, too, move, and play with all the heart creak.
strengthening the foundation
magnesite plate - have you heard of such a material for finishing? I think that is not often. Many will not write about it, so it is difficult to find information not. I can only say that ONET is not very cheap, well, not very expensive.
1. In size and plate thickness magnesite resembles a standard gypsum board 2,5h1,2 m but slightly different and because of the high density weighs more. Often different thicknesses, even up to 30 mm. I took 10 or 12 mm, can not remember exactly.
2. On one side is adhered increases the strength of glass net, so sometimes you can meet also another name for the material - Steklomagnezitovye plate.
3. Plate lay on the floor is not difficult. Vrazbezhku do it better and fix the screws. Much of a difference on which side lay I did not notice. Tried and true.
4. Cut with an ordinary knife, make an incision and gently enough but to break it.
5. For fixing using ordinary black screw on wood. Only when a sheet of gypsum they need about 60 units, and for magnesite plates - 70-80 pieces, in general, do not be sorry.
Need to fasten a sheet around the edges, with a pitch of up to 15 cm in the middle and plump on the entire plane. Since the board or that they do not always lie exactly, you should try to press the plate to the floor as much as possible.
If you leave gaps between the stove and the floor, then moistened with a little stove tile adhesive will soften and prosyadet on the board, and laid tile on the place - no, and maybe in some time may peel off.
Stove with a strong bend and pressed to the floor may crackEspecially at the edges, so when mounted on the screwdriver bit is necessary to put a limiter, which allows to tighten screw no longer necessary.
Before laying the tiles bolted plates will not prevent primed. Now there is every guarantee that the new floor will YX! At this until all.
Put huskies, comment, and subscribe - SUBSCRIBE.
Read more:
The new trend in the finishing slopes
Flexible hose, which should be discarded. Master OK
Installation of a plinth in unusual corners. Master OK
Choosing a faucet thoughtfully. Master OK