Installation of a plinth on the straights. Master OK
Do not blame me friends that important milestone left for last. Let me remind you that have posted positions in the last two days of selection of accessories and furniture fittings Skirting and installation of non-standard angles. Now, only a number of nuances to install skirting strips. Read to the end, you will learn how to eliminate the gap between the wall and the skirting.
1. mood
Easily can spoil even the simplest job, so to, like, the simple task of installing skirting on linear sections treat as a small exam, for which get just two assessment - professional and material.
2. Training
Nailing the first plinth recommend viewed from the angle that the joint was away and less noticeable. Remove the strip-cover in the middle of the plinth and look for the presence of the mounting holes. They have not always or often located too far from each other, so you should be guided by the distance between the fasteners 35-40 cm.
The inner corner on a plinth set once and be installed along with it. Skirting comes into it at 0.5 cm, than you need to make sure in advance and to take into account this point, when you trim.
3. mount
I was lucky, because modelc got through with holes 35 cm, which gladly took advantage of. But if there is no ready-made holes, they can be punched in the course of work puncher. By experience I would say that if you put the bar so that it does not lie down to the back wall, the punch Dig plinth, and does not break it and throwing up the whole piece, and the resulting hole in the plug to fail along with the ears, so I exhibited before drilling the wall and well cuddle.
Drill a hole in the baseboard can be in the unstressed mode rotary hammer, then surely all will be ok!
Specifically removed by 6x40 mm closer to the photo mounting dowel. From this position it is possible to tighten with a screwdriver, screwdriver or a hammer hammer, putting something. I have in store for this old Phillips screwdriver. I knocked a couple of times and you're done. This fixture is called "dowel-nail," and it is specifically designed for precast operations, even smoothed carving on it, so as not to burst the plastic funnel.
When driving the screw into the wall in the terminal phase is better to use a screwdriver as a blow can break through the plinth and slip the dowel into the wall and will not fix his hat.
4. Compound
The edge of the plinth is fixed at a distance of 5-7 cm, as in the photo. Further push-fit connector and take the next bar. The connector is not screwed on, but keeps only a plinth. It has special antennae for that and need to start the baseboard to a depth of half a centimeter.
5. Installation of decorative strips
By installing two or three plinths can be inserted in place of boxes strips, but so that they, too, went into the corner and the connector. But if the cover does not become, it is impossible to beat strongly. Break, I think it is not broken, but it is inside the drive in turn.
Better again to remove a decorative strip and clean of debris landing slots, especially in places opposite to the openings of which during drilling is guaranteed something to pour.
Yes, as promised at the beginning: if the wall is not smooth, the anchors are set more often than usual, which will allow to press tightly against the wall plinth. If still remains, do not worry between the skirting and the wall of the small gap, try setting bar in the midst of a plinth and it is sure to further push the plinth up and down and giving his wall. That's the math!
Articles as well as subscribe to a channel -SUBSCRIBE.
Read more:
Flexible hose, which should be discarded. Master OK
The new trend in the finishing slopes
Weak pressure for no apparent reason? We solve the problem!
Mouse PC gone mad? 5 minutes and order. See how!
Guess which of the heel? Do not believe it!