Enraged mouse? 5 minutes and order. See how!

The problem with computer cursor mouse running around on the screen familiar to most users, but how to deal with it know not many. There is an effective way that can be experienced when others do not help.

Usually calm the mouse users try to change various settings, but if it is not useful, you can do one more thing:

1. Myshu laid on its back and look at a small window in the center, where the optical lens. Often all that is needed is good to blow it and gently wipe the microfiber or other non-rigid fabric. But if it does not calm your mouse, to perform a couple of actions.

2. Take a small Phillips screwdriver, unscrew the single screw and remove the bottom cover. See approximately the picture (see. a photo).

3. Take fingers and gently remove the optics. It is usually not how it is mounted, but just quietly sitting on the board. So just we pull out.

4. Now, we find a soft cloth, microfiber better or something similar and wipe it from all sides, leaving no fingerprints, especially in the round monocular with a lens that is visible in the middle. Often, due to dust reflected rays it is not correct, which causes the cursor jumps around the screen.

5. We put this little miracle on board and set a fee in place, if it is moved. Now close the lid and fasten the screw. That's the end of the song! Simple, right?

These simple steps take just 5 minutes. Sometimes it is very rescued and saved by replacing the beloved mouse. So experiment!

Subscribe to the channel "Master OK" and enjoy reading beneficial to all and sundry in the repair, construction and even home technology.