Errors in laying aerocrete: how not to build a house alarm

About talked a lot on our channel. Today, we consider what errors happen when laying aerocrete. For the construction of increasingly using D500 density. This density allows to spread the building up to 3 floors.

If you are advised to buy when buying gazoblok for building a house, for example, the D300 density, it is not necessary to believe it. Even if the foundation is properly implemented, it would still be a problem. Cracks appear in the blocks.

Aerated concrete is easy to saw, drill holes in them, hammer in nails. Blocks of lightweight and environmentally safe for humans. Houses made of aerated concrete is recommended to construct monolithic strip foundations.

D300 density even for the fences do not use experienced craftsmen, not something for the house. In such a house will suffer interior facade.

Now for another important condition for aerated concrete masonry. The maximum thickness of the seam between the blocks should be no higher than 4 mm. Apply the grout is not recommended. It is best to glue.

If you are using along with Gazoblok brick, the brick inserts need to insulate. If the insulation is not done, then over time in these areas will freeze wall to form mold.

When laying rows of aerocrete may be slight differences in height. These places (joints) between the blocks need to overwrite float:

Be sure to remove all the dust and then moisten slightly.

When the masonry blocks on their output level. For general marking hammer on the boards of the perimeter. They pull the rope.

Most responsible - laying the first row. On the foundation laid roofing material.

Too thick adhesive should not be used. The consistency should be like thick cream. is too liquid to flow, spread through the surface of the blocks. Liquid glue will be impossible to align the level of (trim, little perch) blocks.

The solution was applied to the side of the unit stacked and removed toothed trowel (6-8 mm.). How to shoot vertically or horizontally? Some say that if you shoot horizontally, it will be blowing. Shoot glue vertically. While laying on the glue, baste a broom dust a new block.

channel RemontDom. Subscribe Like place - thank you and all the best!