How to make a handle on the tongs from a strip of plastic bottles. First experience

Conceived to make the coating on the handles of the tool from a strip of plastic bottles, to cut the strip, I had to make butylkorez, leave a link to it at the bottom of the article.

Problem

Coating handles burst and collapsed two days later that I was very surprised, because in the past, exactly the same ticks were not a problem.

It would be possible to use heat shrink, but my choice fell on the tape that shrinks when heated, too, in the form of a base.

Performance

Tape wrapped around the handles overlap and blasted with a hairdryer. She sat tight in their form. But since this was doing for the first time, it was not without incidents. The bandwidth was too broad and the final stage was unable to fill tape in closing an overlap.

I came out of the situation, another strip of a transparent bottle, which was already, and it stalled the main stream and besieged hairdryer. The next time you will experience in this business, but for now do not judge strictly.

With this film people doing a lot of things, so I think, over time, I continue this theme with new crafts.

instagram viewer