How to make a reusable fittings for soldering

The following describes a method that allows you to use multiple fittings for soldering.

prehistory

Recently soldered bath mixer, it was night, I went out one unfortunate mistake. And as you know, polypropylene not immediately soldered correctly and with concentration, or to be cut and replaced by coupling.

What to do? I had to wait in the morning and again in the store for other fittings to go, it's not you fittings on metal-base, and shoot me on the other.

Decision

I did not want to wait, and I decided to remedy the situation, but how? And here comes the solution.

Since the pipe I had twenties, decide Drill the seat tube solder crown wood 18 mm.

For this purpose a pipe cut off flush with the fitting and soldering iron in the middle, make a seat for the crown, Drilled, and the fitting is ready for soldering.

For the experiment, repeat this procedure five times, and then cut a tee to see the result.

Tee used as an example, he kopek and it is not a pity, but this method is suitable for other expensive fittings.

Output

method working, And so I became convinced in the mixer, but for water three times is enough for heating with natural circulation once accurately convert think will go.

But to use the DIY as you want, as long as the look satisfied.

Videopoyasnenie

Subscribe and share with friends on social networks, and we again think of something.

On this topic:Homemade bath mixer polypropylene