How exactly embed loop manually in interior doors

Manual punch

Similarly, embedded, loops without unnecessary gaps adorn any door, so all of the masters in this endeavor.

Box itself is not a complicated process, if you observe all the tried and tested recommendations. But you should know that the hand-tie-loops in the canvas and the box covers most of the time installing the door.

dimensions

At the door loop bumps with a space from the edge of 20 cm, and in a box is indented 20.3 cm.

marking

Attached to the indent of ground loop is outlined sharply with a pencil, then cut mark office knife.

However, in recent years I am using a different method. Fasten the noose on the place of the future installation of a self-tapping pressshayboy, put it under her head nylon washer, so as not to damage the finish loop. And then right at the loop knife Cutting through this option give you to choose from.

incut

Box manufacture chisels, you can buy a set, and you can, buy all three pieces 25, 19 and 13 mm, as shown by my practice, these rooms are the most running tapping hinges and lock.

I recommend the back side after the stroke outline loop, as is often the geometry of one card loop does not coincide with the other, if do so, then each card sits at one place as poured.

installation

The carved groove insert loop and make an awl to mark-drilling screws, moreover, do not offset to a large box or door leaf. Then the heads of the screws tight loop card is pulled toward the edge of the groove.

Marked drilled drill place of 2 to 2,3 mm, this would facilitate tightening of the screw and prevent cracking of the material.

The main idea of ​​the article is that a groove is cut for a specific card loopBecause it can have different sizes and shapes, then loop sits precisely and accurately.

video description

All dimensions in the interior doors can see here.

Subscribe and share with friends on social networks, your home renovation.