How to cut cleanly ceiling moldings in the corners without miter box the first time
Ceiling moldings ceiling completes the finish. It masks the gaps and defects. But sometimes it is very difficult to join in the corners of the plinth. Ceiling Molding some call quirk. Today describe how to cut a corner plinth without miter box.
External and internal angle can be done smoothly and without spec. instruments.
Plinth are sold in different shapes, colors. Usually this white plinth. We are looking for a beige, but have not been found.
On sale is a ready-angles to the profile. This is for those who do not want to spend time cutting corners and glue the ready.
These 4 corners in a hardware store we have managed for 185 rubles. Expensive, but quick and easy. However, we did not know the method described below, otherwise I would not have spent the money for nothing.
For those who want to save a simple instructions on how to cut straight angles (see below).
Proper selection of the plinth is also important. If the ceilings are high, it is best to choose a plinth.
It seems there is nothing easier to cut the corner. Previously, when we started doing this, we have nothing good came out:
That's because every corner of the room is not the same. One angle may be 90 degrees, another 87. Therefore, if cut at an angle skirting exactly 45 degrees can turn backlash.
I do not receive both external and internal angle:
Only later did we find on the Internet is one piece of advice, how exactly to cut every corner moldings.
Cutting skirting without stuslo
Making the markup directly on the ceiling. Cutting by means of plinths stationery knife.
- Take the plinth. We apply it where an angle close. Now, with a conventional pencil draw line along the top skirting. Then remove the fillet and applied from the other side of the angle.
- We draw the same line on the top floor. That will have two lines that intersect.
- From the intersection point put a mark on the floor. From the mark exactly need to draw a line to the corner of the plinth. The same should be done with the second molding.
- From the lines to cut the edge of the baseboards 2. Apply glue to the inside of the skirting boards and glue. That will have a smooth, beautiful angle without the use of special tools.
channel RemontDom - https://zen.yandex.ru/remontsthanks for viewing and huskies! We wish you all a quality repair.