There was no plane at hand for the GCR. The simplest adaptation helped out, which I made in just a few minutes.

When installing drywall sheets it is important to smoothly and efficiently dock them.

But do it difficult immediately after cutting the material, as it turns out an uneven edge, which also crumbles or chips off.

therefore edgeGKL sheets necessary additionally process.

Usually a special tool is used for these purposes. - drywall planer.

And everything would be fine but it is not always at hand.

Of course it is possible, interrupt the workflow and go in search of it.

In the absence of such an opportunity, you can solving the problem is quite simpleby making homemade device in just a few minutes. How? Consider below.

I had such a case.

Colleague by mistake, in a hurry, he grabbed my GKL plane along with other instruments and took him to another facility.

As a result, I left without a tool for the whole day. And the amount of work was going to be quite large.

I had to solve the problem quickly and in the simplest possible way.

Helped me out homemade device, which, as it turned out later, performs its functions no worse than the factory version.

For the manufacture of "fit" took unnecessary trimming the rack profile.

Via screwdriver from the inside of the profile began to tighten the self-tapping screw.

It was not very convenient to do this on weight.

therefore posted a profile on unnecessary a piece of drywall and continued making holes.

As a result, the profile has grater-like surface.

I did not become wise any more and started directly to work. As a temporary optionsuch a homemade plane was quite useful.

Butif you plan to use such a plane permanentlythen bettermodify it(add, for example, a bar or profile on top, to make it easier to hold the device in your hands).