Acquired ceiling moldings, decorative corners but could not find them. How can dock them at the right angle

Recently purchased a ceiling moldings, decorative corners but could not find them. The question arose: how to dock them at the right angle, because the curved surface? Searched on the Internet, it was quite easy problem is solved by a tool such as a miter box.

Note.Miter - carpenter's tool for cutting molded material at an angle. This box with lateral cuts at angles of 45 ° and 90 °.

So, to cut a corner of ceiling details baguettes will need the following tools:

• miter box;
• hacksaw;
• Construction knife.

Furthermore, it is necessary to observe the correct schema ceiling trim baguettes, as for internal and external circuits different angles.

Scheme ceiling trim baguettes for external corners.

Scheme baguettes ceiling trim for internal corners.

Tip!To avoid errors, pledged right bar baguette miter box to the right, left - the left.

Getting trim moldings:

• Put a bar baguette miter box so that the portion that will be adjacent to the ceiling, lay on the bottom of the miter box. Piece of baguette, which will be adjacent to the wall, to be in contact with the nearest to your wall Miter.
instagram viewer
• Firmly fix the baguette in hand miter box, insert the saw into the guide, make the cut at 45 °.

Important!Clicking the tool on a baguette should be light, otherwise it is possible to deform the part.

• Gently eliminate minor defects (burrs, roughness) using a knife construction. We get the finished part.

• Repeat steps 1-3 for the second baguette bar.

• Putting a plank to the corner, we check how fit together. If necessary, modify sections of the building with a knife and check the dock again.

Now you can safely stick baguettes!

See also:

Installation of roller blinds without drilling (forces of one young lady, disjointed with a drill)

My life hacking repair. Everyone can find a list of particularly successful devices

How to get rid of the gaps between the bath and the wall without using a wizard in just 2 days

Subscribe to the channel, the only way you will be informed of new publications - in front of a lot of new and interesting information!

p.s.: We try to give you the most important, useful information. If you have been interesting and helpful place "like".