From the apartment in his house. Remote control light system
The layout of the lighting control system in the house
I mentioned earlier that even in a flat system was installed remote control light. On the basis of the experience a similar system was installed in the house. What is the essence.
In the building at the time of entry reconstruction two blocks were installed: one in the hall, a second storage room. These two blocks of the first service and the second floor part. A little later, it was installed a third unit, which caters to street lighting. To block the cable goes directly from the introductory panel. Each block includes 10 channels of 1 kW each. From block wire routed to a single point of illumination, which may consist of multiple lamps. T. e. chain: a block-wire lamp. No intermediate boxes, circuit breakers, respectively, twists, adhesions and the like. D.
RADIO commands are supplied to the block channel.
For each channel unit can be connected finite number of switches, but how much - I just do not remember, just a lot. In my practice, I connected the maximum - 5. For example, the right switch on the photo above is working in parallel here with the switch in the hall:
And to the same switch in the street. All of them include two of the six channels of street lighting at home. Incidentally, the external lighting of the house is now so.
Just something a lot? The house is not so? And then. I really tortured you inzhenerki, I should be a little shake.
There are power units, single-channel, small. They can be inserted directly into the luminaire or in the junction box. I applied them in part on the second floor. I'm sorry, your photos there, they are all hidden.
All power units are combined into a single system and can be controlled via the Internet. T. e. They are part of a smart home.
With regards to switch - is also in the form of a remote control, which is in the car and at the entrance to the yard, I include mood lighting or turn it off when leaving. There is a switch in the bedroom, which is configured to enable or disable all lighting points, ie. E. everything. There are switches on the motion (in my house there, his hands did not reach), etc., etc..
The kitchen has 4 light level. Now the two are working. The rest will be sold with a new kitchen.
Oh, I forgot. It should be a single unit in a well in the summer immersion pump outlet. It is very convenient when working with hoses, nozzle changing, increasing, and so on. D. remotely switch-off the pump.
Once again I draw your attention: the system can be assembled in any lighting company, but of course the best of "from scratch": one wire from the unit to the point. The safest in terms of further operation of the house option. Ground floor I fully able to do so. The second part, combining a single-channel.
Previous post - Networks: heat management.
Next post - the results of the first half of 2017.
More stories - in the thematic section.
Subscribe to the channel. Share in social networks. Join FORUMHOUSE.