5 common mistakes when laying laminate

Laminate flooring is a cheap and practical material, which is not inferior to the beauty of other floor coverings. Self-laying laminate is fairly simple, but it is still possible to make mistakes. And further data errors can entail great problems, such as gaps and cracks or floor curvature. Therefore it is necessary to disassemble the typical errors when laying laminate.

1. Leveling the floor

At the initial stage should be given to alignment of a base. It is necessary that the floor was perfectly flat, clean and dry. If the floor is even with unevenness in 2 mm, then eventually it will creak and there are problems with fixing the laminate. It is best to prepare to use self-leveling mixture.

2. indoor climate

After buying laminate should be kept it under certain conditions. About a day you need to hold the laminate in a room with a temperature of about 21 degrees with 50% humidity. This allows the material to adapt to the operating conditions. Best of all, that for this time the room was already completely ready for laying the floor covering.

3. dry basis

Since the main Lamit material is wood, the coating has a property of expanding under high humidity. It is necessary to completely dry the screed, for example, a layer 4 cm screed need to wait about a month to dry completely. If stacking is carried out on the concrete, its moisture content should not exceed 4 per cent.

4. substrate question

The substrate is not unimportant part when laying laminate. With the help of heat and sound insulation are performed. It is best used as a substrate technical cork.

5. freedom of laminate

In order to further laminate coating served long, you must comply with all the rules during installation, especially to focus compliance gaps standards around the perimeter of the cover. Due to the fact that the laminate can vary in size due to moisture, it is a floating material. So you need to make a small gap of about 2 cm from the junction. The walls of the lumens in the future, you can close a plinth. If this rule is observed, the further operation of the laminate floor will not be deformed.

The laminate is a material which is not fixed nor glue or screws or screws. Therefore, you must carefully review the instructions for installation and comply with these tips to future floor served for a long time.