How to restore the furniture stapler. 4 chips. Master OK

Greetings to you, guests and loyal readers! Today you are a guest of the repairs.

It's nice when the tool is running smoothly and quite the contrary, when a lot of time is spent on his "revival! That's why undertook barahlyaschy stapler for the purpose of anything to improve.

Assort stapler, but not all

Since there is cause permanent problem with a bang, we had to go inside the building (furniture) stapler. For this:

• unscrewed the top adjusting screw (Responsible for the force of impact).
• Stripped off locks the upper and lower studs and pulled them out.
• pulled spring brackets of a block feed.
• pulled from inside striking a spring nut andhimself hammer mechanism.
• He withdrew from the end cover.

Spread everything happened that seen in the picture 2. More did not dismantle anything.

improvements

1. Shoe suspension. The unassembled damper seen from the end in the form of rubber pads, which are pressed many bent staples. The picture shows only a quarter of what it was, the rest flew and dug, and this is for illustration purposes only. Step though simple but will help get rid of jamming due to ingress of staples in the mechanism.

2. Straightening the housing cover. Because sometimes the striker shoots on two brackets together, decided to take a hammer to turn in the top cover in place of the output clamps. It turned slightly reduce the gap and now two do not exactly jump out. It is important not perestuchat, if the striker does not take place then.

3. Eliminating generation in the striker housing. Generation was slight, so trim up to 90 degrees turned out quite quickly. This has helped a large file.

Due to the great development of the stapler fires ahead of time, since the hook or beak, which is the handle, simply slide off when pressed.

The rest of the percussion unit seems to be beyond question.

4. Installing growers. I found a couple of lock washers and put them into a refined nose of the adjusting screw. It could be a washer of the same diameter. This course is caused by the fact that the spring is weakened and eventually at blow compressed / decompressed not with such force. Due to the lining engravers it can draw in a further 4-5 mm, it becomes harder and better striker scored braces. But this number is not passed on all models, as there is a structural difference.

After the assembly passed the test "fire" in a tough desyatisloynuyu plywood. Bracket to 12 mm, is certainly not driven all, but 5 and 6 mm sank completely, and that is what is necessary. And pleased that the two brackets are no longer fly. Compared with what was obvious improvement!

If you approve the material, put a Like. And more sign up per channel, so as not to miss out on something new and different!

Read more:

Complete mixer hoses: strength test

Homemade knife sharpener on a drill of the abrasive wheel

A new way to trim ceiling moldings

Wallpaper glue without brush and tearing off the walls